Tarmo XTP120 Instruction Manual page 62

Replacement Shear Pins
Pair of replacement auger shear pins and clevis
pins is included with your snow blower. Store them
in a safe place until needed.
Spare Roll Pins
The impeller is secured to the impeller shaft with
roll pins.
Two 6x37 roll pins for impeller are supplied as
spare in the hardware bag. Store them in a safe
place until needed.
Battery (if so equipped)
1. Remove the battery cover by loosening the
screw and nut.
2. Take battery out of the tray
3. Attach the tray to the auger housing with
screws and nuts.
4. Replace battery on the tray.
5. Connect positive (red) battery cable to the
battery terminal first, and then negative (black)
battery cable. Check that all cable connectors
are tight.
6. Reinstall battery cover and tighten the screw
and nut.
62