Tarmo XTP120 Instruction Manual page 57

Do not run the engine indoors, except when
starting the engine and for transporting the snow
blower in or out of the building. Open the outside
doors; exhaust fumes are dangerous.
Always check overhead and side clearances
carefully before operation. Always be aware of
traffic when operating along streets or curbs.
Thoroughly inspect the area to be worked. Keep
the working area clean and free of toys, doormats,
newspapers, sleds, boards, wires and other
foreign objects, which could be tripped over or
thrown by the auger. Check for weak spots on
docks, ramps or floors.
Plan your snow-blowing pattern to avoid discharge
toward people or areas where property damage
can occur.
Do not operate near drop-offs, ditches, or
embankments. Machine can suddenly turn over if
a wheel is over the edge of a cliff or ditch, or if an
edge caves in.
Keep all bystanders, children, and pets at least
23m (75 feet) away. If you are approached, stop
the unit immediately.
Use a grounded three-wire extension cord and
receptacle for all machines with electric start
engines.
Check clutch and brake operation frequently.
Adjust and service as required. All motion of drive
wheels and auger must stop quickly when control
levers are released.
Let engine and machine adjust to outdoor
temperature before starting to clear snow.
Stay alert for hidden hazards or traffic.
Do not overload machine capacity by attempting to
clear snow at too fast of a rate.
Do not blow snow any higher than necessary.
Adjust auger housing height to clear gravel or
crushed rock surfaces. Exercise extreme caution
when operating.
Exercise caution to avoid slipping or falling,
especially when operating in reverse. Never
operate machine at high transport speeds on
slippery surfaces. Always look down and behind
before and while backing.
Do not operate on steep slopes. Do not clear snow
across the face of slopes. Keep all movement on
slopes slow and gradual. Do not make sudden
changes in speed or direction. Use a slow speed
to avoid stops or shifts on slopes. Avoid starting or
stopping on a slope. Do not park machine on a
slope unless absolutely necessary. When parking
on a slope, always block the wheels.
Disengage power to the auger when transporting
or not in use.
Disengage all control levers and stop engine
before you leave the operating position (behind the
handles). Wait until the auger comes to a complete
stop before unclogging the chute assembly,
making any adjustments, or inspections.
Hand contact with the rotating parts inside the
discharge chute is the most common cause of
injury associated with snow blowers. Do not unclog
chute assembly while engine is running. Shut off
engine and remain behind handles until all moving
parts have stopped before unclogging. Never put
your hand in the discharge or collector openings.
Always use the clean-out tool provided to unclog
the discharge opening.
57