Tarmo XTP120 Instruction Manual page 61

(attached to the crank lever) to the upper left
side of the handlebar with a locknut and two
curved washers.
4. Apply grease to the spiral of the crank lever.
5. Insert the spiral end of the crank lever into the
lower bracket and secure with the flat washer
and clevis pin.
Tires
The tires are over-inflated at factory for shipping
purposes. Check the pressure in the tires. Reduce
or Increase equally in both tires to the
manufacturer's recommended pressure.
Under any circumstance do not exceed
manufacturer's recommended pressure.
Excessive pressure when seating beads
may cause tire/rim assembly to burst with
force sufficient to cause serious injury.
Refer to side wall of tire for recommended
pressure.
Equal tire pressure should be maintained
at all times. If the tire pressure is not equal
in both tires, the machine may not travel in
a straight path and the shave plate may
wear unevenly.
Keep tires free of gasoline and oil, which
can harm rubber.
Skid Shoes
1. Move the machine to a level surface.
2. Support the auger blades so that they are 3
mm off the ground.
3. Check the scraper blade adjustment. The
scraper should be 3 mm above and parallel to
a level ground. To adjust the scraper blade,
loosen the mounting screws (two on each
side), level the scraper blade, and tighten the
mounting screws.
4. Attach both skid shoes to the auger side plates
with the screws and nuts. Move the skid shoes
down as far as possible. Be sure both skid
shoes are adjusted evenly. Tighten securely.
Chute Clean-Out Tool
Fasten the clean-out tool to the mounting clip on
the rear of the auger housing.
61