Tarmo XTP120 Instruction Manual page 74

Holding down the drive clutch lever will
ease reinstallation of the belt.
If an assistant is available, you can also separate
the auger housing from the frame assembly to
replace belts.
1. Shut off engine, remove key, disconnect spark
plug wire and allow unit to cool completely.
2. Remove belt cover.
3. Remove the clevis pin and washer from the
chute crank lever to remove it from the lower
bracket.
4. Remove bottom cover to avoid bending it
when tipping unit apart.
5. Remove the screws securing auger housing to
the frame (two on each side). Tip auger
housing and frame apart.
6. Replace auger belt or drive belt.
7. Tip auger housing and frame back together
and secure with screws.
Holding down the auger clutch lever will
ease reconnection of the auger housing
and frame.
8. Place belt(s) onto engine sheave(s).
9. Reinstall the chute crank lever.
Friction Wheel Replacement
If the snow blower fails to drive with the drive
clutch engaged, and performing the clutch control
cable adjustment fails to correct the problem, the
friction wheel may need to be replaced.
1. To prevent spillage, remove all fuel from tank by
running engine until it stops. Remove the key to
avoid unintended starting and allow unit to cool
completely.
2. Carefully pivot the snow blower up and forward
so that it rests on the auger housing.
3. Remove the frame cover(s) from the underside
of the snow blower by removing the screws
which secure the cover(s).
4. Remove the right-hand wheel by removing the
axle lock pin.
74