KTM 450 EXC-F 2017 Repair Manual page 60

7
HANDLEBAR, CONTROLS
58
M00993-l l
M00987-ll
(EXC-F EU/AU/US)
Remove screws
0 .
Take off the handlebar clamps. Remove the handlebar and
lay it to one side.
• Info
I
Cover the components to protect them against damage.
Do not kink the cables and lines.
Remove screws
8 .
Take off the handlebar supports.
Place the hand lebar supports in the required position. Mount and tighten
screws
8 .
Guideline
Screw, handlebar holder
• Info
MlO
40 Nm
(29.5 lbf ft)
I
Position the left and right han dlebar supports evenly.
Position the handlebar.
• Info
Loctite® 243™
I
Make sure the ca bles and wiring are positioned correctly.
Position the handlebar clamps. Mount screws
0
and tighten evenly.
Guideline
Screw, handlebar clamp M8
• Info
I
Make sure the gap w idths are even.
(All EXC-F Six Days)
20 Nm
(14.8 lbf ft)
Remove screws
0 .
Take off the handlebar clamps. Remove the handlebar and
lay it t o one side.
• Info
I
Cover the components to protect them against damage.
Do not kink the cables and lines.
Remove screws
8 .
Take off the handlebar supports.
Place the hand lebar support s in the required position. Mount and tighten
screws
8 .
Guideline
Screw, handlebar holder
• Info
MlO
40 Nm
(29.5 lbf
ft)
I
Position the left and right han dlebar supports evenly.
Position the handlebar.
• Info
Loctite® 243™
I
Make sure the ca bles and wiring are positioned correctly.
Position the handlebar clamps. Mount screws
0
and tighten evenly.
Guideline
Screw, handlebar clamp
M8
• Info
I
Make sure the gap widths are even.
20 Nm
(14.8 lbf ft)