KTM 450 EXC-F 2017 Repair Manual page 137

15 WIRING HARNESS, BATTERY
Main work
Pull EFI control unit
0
from the holder and hang it to one side.
Open fuse box cover
8 .
Remove the defective fuse.
Guideline
(EXC-F EU, EXC-F Six Days EU)
Fuse 1 - 10 A- EFI control unit, lambda sensor, speedometer, combination
switch (optiona l) , fuel injection , diagnosti cs connector, fuse 4
(EXC-F AU)
135
Fuse 1 - 10 A- EF I control unit, speedomet er, combination switch (optional) ,
fuel injection , diagnostics connector , fuse 4
(All US models)
I
Fuse 1 - 10 A- EFI control unit, speedometer, fuel injection, diagnostics
connector, fuse 4
Fuse
2 -
10 A- high beam, low beam, parking light , tail light, license plate lamp
Fuse 3 - 10 A- radiator fan , horn , brake light, turn signal
Fuse 4 - 5 A- fuel pump
Fuses res - 10 A - spare fuse
Info
You can recognize a defective fuse by a burned-out fuse wire
f) .
Warning
Fire hazard Incorrect fuses overload the electri cal system .
Only use fuses with the required ampere va lue.
Do not bypass or repair fuses.
Use spare fuses with the correct rating only.
Fuse (75011088010)
( ~
p. 265)
Fuse (58011109105) ( ~ p. 265)
• Tip
I
Replace the spare fuse in the fuse box so that it is available if needed.
Check that the power consumer is functioning properly.
Close the fuse box cover.
Mount EFI control unit
0
on the holder.
Finishing work
Mount the seat.
(@!
p. 102)