KTM 450 EXC-F 2017 Repair Manual page 127

14 WHEELS
14.8.4
Changing the rear wheel bearing
Preparatory work
Raise the motorcycle with the lift stand.
( ~Eli
p. 11)
Remove the rear wheel.
(eJ!
p. 123)
Main work
Remove shaft seal ring
O .
Remove lock ring
8 .
Remove shaft seal ring
8 .
Using a suitable tool , press bearing
8
out from the inside to the outside.
Remove spacing tube
0 .
Using a suitable tool, press bearing
0
out from the inside to the outside.
Check spacer washer
0
for damage and wear.
»
If the spacer washer is damaged or worn :
Replace the spacer washer.
Position spacer washer
0 .
Press new beari ng
0
all the way in from the outside to the inside.
• Info
I
On ly press the bearing in via the outer ring otherwise the bearing will be
damaged when it is pressed in .
125