Troubleshooting; No Light - SHOWTEC Compact Blinder 2 Manual

Compact Blinder 2

Troubleshooting

This troubleshooting guide is meant to help solve simple problems.
If a problem occurs, carry out the steps below in sequence until a solution is found. Once the unit
operates properly, do not carry out following steps.

No Light

If the light effect does not operate properly, refer servicing to a technician.
Suspect three potential problem areas as: the power supply, the lamp, the fuse.
01) Power supply. Check if the unit is plugged into an appropriate power supply.
02) The lamp. Replace the lamp. See page 8 for more information.
03) The fuse. See page 9 (Replacing the Fuse) for more information.
04) If all appears to be O.K., plug the unit in again.
05) If you are unable to determine the cause of the problem, do not open the Compact Blinder, as this
may damage the unit and the warranty will become void.
06) Return the device to your Showtec dealer.
Problem Probable cause(s)
One or more
No power to the fixture
fixtures do not
function at all
Primary fuse blown
Fixture is too hot
No light or lamp
cuts out
Lamp is damaged
intermittently
The power supply settings do not
match local AC voltage and
frequency
Ordercode: 30605
Solution
• Check if power is switched on and
cables are plugged in
• Replace the fuse.
• Allow the fixture to cool down
• Make sure air vents are not
blocked
• Turn up the air conditioning
• Disconnect the fixture and
replace the lamp
• Disconnect fixture. Check settings
and correct if necessary
10