Table of Contents
Advertisement
Figure 11 Connecting an optical fiber
Installing a power module
The device supports only AC power modules.
To install a power module:
1.
Remove the blank filler panel (if any) from the slot where you want to install a power module
with a Phillips screwdriver.
Keep the remove blank filler panel for future use.
2.
Holding the handle of the power module with one hand and supporting the bottom of the power
module with another hand, push the power module into the slot along the guide rails until the
power module is completely inserted.
3.
Use a Phillips screwdriver to fasten the screws on the power module.
Figure 12 Installing an AC power module
1
3
11
2
4
Advertisement
Table of Contents
