Installing A Drive - H3C WX3820X Installation Manual

Figure2-18 Installing an expansion module

Installing a drive

CAUTION:
Do not hot swap drives.
The device does not come with any drives. Purchase drives as needed.
To install a drive:
1. Wear an ESD wrist strap and make sure it makes good skin contact and is reliably grounded.
2. Remove the filler panel from the drive slot.
3. Press the button on the drive panel to release the locking lever.
4. Hold the locking lever and push the drive into the slot slowly along the guide rails. Then close
the locking lever.
Figure2-19 Installing a drive
2-16