Sears Kenmore 73611 Use, Care, Safety Manual page 8

InstanUation Snsttuctions <contin.ed>
A: Usage Situations where Appliance Power Cord
will be Disconnected.
An adapter may be used only on a 15-amp circuit° Do
not use an adapter on a 20-amp circuit. Where local
codes permit, a TEMPORARY CONNECTION may
be made to a properly grounded two-prong wall
receptacle by the use of a UL-listed adapter, available
at most hardware stores_ The larger slot in the adapter
must be aligned with the larger slot in the wall recep-
tacle to provide proper polarity in the connection of the
power cord.
TEMPORARY METHOD ._ ___
(ADAPTER PLUGS NOT
PERMITTED IN CANADA) _--_ ,_"
PRONGS/SLOTS
N
BEFORE USE
CAUTION: Attaching the adapter ground terminal
to the wall receptacle cover screw does not ground
the appliance unless the cover screw is metal, and
not insulated, and the wall receptacle is grounded
through the house wiring. The customer should
have the circuit checked by a qualified electrician
to make sure the receptacle is properly grounded.
When disconnecting the power cord from the adapter,
always hold the adapter with one hand_ If this is not
done, the adapter ground terminal is very likely to
break with repeated use. Should this happen, DO
NOT USE the appliance until a proper ground has
again been established°
B: Usage Situations where Appliance Power Cord
will be Disconnected.
Do not use an adapter plug in these situations
because disconnecting of the power cord places
undue strain on the adapter and leads to eventual fail-
ure of the adapter ground terminal° The customer
should have the two-prong wall receptacle replaced
with a three-prong (grounding) receptacle by a quali-
fied electrician before using the appliance°
The installation of appliances designed for mobile
home installation must conform with the Manufactured
Home Construction and Safety Standard, Title 24
CFR, Part 3280 (formerly the Federal Standard for
Mobile Home Construction and Safety, Title 24, HUD,
Part 280) or, when such standard is not applicable,
the Standard for Manufactured Home installations, lat-
est edition (Manufactured Home Sites, Communities
and Set-Ups), ANSI A225ol, latest edition, or with
local codes.
Electrical Disconnect
1. Locate disconnect plug on the range back.
2. Pinch sides of connector and putl out of range back,,
You will have one of these disconnect plugs:
8