Sears Kenmore 73611 Use, Care, Safety Manual page 11

Oven Bottom
To remove the oven bottom:
1. Remove the knurled screws holding down rear of
the oven bottom.
2. Grasp the oven bottom at finger slots on each side°
3. Lift the rear of the oven bottom enough to clear the
lip or range frame, then pull out.
Step 8
Leveling the Range
1. Remove the storage drawer_ Pull drawer out all the
way and lift front of drawer up to remove.
Remove Screw
on some
models
To remove the burner baffle (on some models):
1. Use a nut driver to remove the t/4" hex head screw
shown in the illustration above. Do not remove any
other screws.
2. Pull baffle straight out until it is free from the slot
that holds it at rear of oven_
2. Use a 3/16" open-end or socket wrench to back out
both rear leveling legs approximately two turns.
3. Use a t%" open-end or adjustable wrench to back
out the front leveling legs two turns.
4. Install the oven shelves in the oven, then position
the range where it will be installed.
5. Check for levelness by placing a spirit level or a
partially filled cup of water on one of the oven
shelves, if using a spirit level, take two readings--
with the level placed diagonally first in one direction
and then the other..
6. Adjust the leveling legs until the range is level_
7. After the range is level, slide the range away from
the wall so that the Anti-Tip device can be installed_
(continued next page)
11