Sears Kenmore 73611 Use, Care, Safety Manual page 37

After a Clean Cycle
When the clean cycle is finished, the word "CLEAN"
will go out in the display and the oven will begin to
cool. When the oven temperature has fallen below the
locking temperature the word "LOCK" goes out and
the door can be opened.
After a clean cycle, you may notice some white ash in
the oven. ,,lust wipe it up with a damp cloth, tf white
spots remain, remove them with a soap-filled steel
wool pad Be sure to rinse thoroughly with a vinegar
and water mixture. These deposits are usually a salt
residue that cannot be removed by the clean cycler
If the oven is not clean after one clean cycle, the cycle
may be repeated
How to Delay Start of Cleaning
Delay Start is setting the oven timer to start the clean
cycle automatically at a later time than the present
time of day NOTE: Before beginning, make sure the
oven clock shows the correct time of day
Quick Reminder--Delay Start for
Self-Clean:
1. Prepare the oven for cleaning.
2. Close and latch the oven door
3, Press the CLEAN pad.
4. Press the INCREASE pad tf you wish to
change preset clean time of 4 hours, press the
INCREASE/DECREASE pad until desired time
appears.
5. Press the STOP TIME pad,
Time that appears is 4 hours later than the time of
day. Press the INCREASE pad until the Stop
Time you desire appears in the display. The self-
clean cycle will automatically begin 4 hours
before the Stop Time you select.
5. Clean Time is preset for 4 hours° You can change
the clean time to anywhere between 2 and 4 hours,
depending on how dirty the oven is. if a shorter
Clean Time is desired, press the DECREASE pad
until the desired Clean Time is displayed°
[ ! 6"PresstheSTOPTIME pad''11:00''
STOP appears on display and "STOP TIME"
TIME
flashes. The control automatically sets
Stop Time by adding the Clean Time to the time of
day° In this example, the time of day is 7:00 and the
Clean Time is 4 hour& Adding 4 hours to the time
of day equals 11:00,
7. Change the Stop Time from 1t :00 to 1:00 by press-
ing the INCREASE pad until "1:00" appears
in the display. The words "DELAY CLEAN" wilt also
appear in the display.
The self-clean cycle will automatically begin at 9:00
and finish at t:0& The word "ON" will appear on the
display at 9:00.
When the oven locks, the word "LOCK" will be dis-
played and a short time later, the door latch handle
will be locked in position° It wilt not be possible to open
the oven door until the temperature drops below the
lock temperature.
When the clean cycle is finished, the word "CLEAN"
will go out in the display and the oven will begin to
cool. When the oven temperature has fallen below the
locking temperature the word "LOCK" goes out and
the door can be opened,,
8. When the LOCK light is off, slide the latch handle
to the left as far as it will go and open the door.
Never force the latch handle. Wait until the word
"LOCK" goes out in the display. Forcing the latch
handle may damage the door lock.
(continued next page)
For example: Let's say it's 7:00 and you want the
oven to begin self-cleaning at 9:00 after you're fin-
ished in the kitchen. The oven has been preset to
clean for four hours,
1o Prepare the oven for cleaning.
2, Close the oven door and slide
the latch handle to the right
Hi_jH_ __ as far as it wilt go. Make sure the oven light is off
Never force the door latch handle. Forcing the
handle may damage the door lock mechanism,
I 3.Press the CLEAN pad°
CLEAN 4. Press the INCREASE pad The oven
is set.
37