Installing The Anti-Tip Device - Sears Kenmore 73611 Use, Care, Safety Manual

Table of Contents

Advertisement

mnstaaRation Qnstructions (cont n ed)
Step
9
Installing the Anti-Tap Device
WARNING:
• Range must be secured
with an approved
Anti-
Tip device.
. Unless
properly
installed,
the range could
be
tipped
by an adult or a child standing,
sitting or
leaning
on an open door or drawer_
• After installing the Anti-Tip device, make sure it
is in place
by carefully
attempting
to tilt the
range forward,,
o This range has been designed
to meet all rec-
ognized
industry
tip standards
for all normal
condition&
o The use of this device
does not preclude
tip-
ping of the range when not properly
installed,,
. If the Anti-Tip
device
supplied
with the range
does not fit this application,
use the universal
Anti-Tip
device WB02X7909.
1. Mark the wall where the RIGHT EDGE of the range
is to be located°
Be sure to allow for the countertop
overhang
if you intend
to install the range
next to
cabinets,,
!
Anti-Tip
I
IOev oo I
/
2W'
/
o"1_kaede
Edge
J
2. Locate
the outside
edge of the device
2W' toward
the center of the range from the marked edge of the
range
3. Using the device as a template,
mark the position of
the hote for the screw
Wallboard
Anti-Tip
Device
Wood Screw
Back of
Range
4_
5_
For wood construction,
drill a pilot hole at an angle
of 20 degrees
from the horizontal.
A nail or awl may
be used if a drill is not available°
Mount the Anti-Tip
device with the screw provided.
For cement
or concrete
construction,
you wilt need
a 1/4" x 1½" lag bolt and a 1/2" O.Do sleeve anchor,
which are not provided.
Drill the recommended
size
hole for the hardware,
Install the sleeve
anchor
into the drilled
hole and
then
install
the lag bolt through
the device.
The
bolts must be properly
tightened
as recommended
for the hardware_
Slide
the range
against
the walt,
and check
for
proper
installation
by grasping
the front edges
of
the
rear
surface
unit
openings
and
carefully
attempting
to tilt the range forward.
WHEN ALL HOOKUPS ARE COMPLETED
MAKE
SURE ALL CONTROLS
ARE LEFT IN
THE OFF POSITION.
MAKE
SURE
THE
FLOW
OF COMBUSTION
AND
VENTILATION
AIR TO THE
RANGE
IS
UNOBSTRUCTED.
12

Advertisement

Table of Contents
loading

This manual is also suitable for:

Kenmore 73618Kenmore 73619Kenmore 73915Kenmore 73919

Table of Contents