Sears Kenmore 73611 Use, Care, Safety Manual page 23

Oven ControU,Clock and Timer
Clock
The clock must be set for the automatic oven timing
functions to work properly, The time of day cannot be
changed during a Timed Baking or a CLEAN cycle,
To Set the Clock:
1. Press the CLOCK pad,
CLOCK
2. Press the INCREASE or DECREASE
pad to set the time of day,
3. Press the CLOCK pad to start,
In Case of Power Outage:
After a power outage, when power is restored the dis-
play will flash and time shown will no longer be cor o
rect--for example after a 5-minute power interruption
the clock will be 5 minutes slow.
All other functions that were in operation when the
power went out will have to be programmed again°
Timer
The timer is a minute timer only; it does not control
oven operations° The maximum setting on the timer
is 9 hours and 55 minutes
To Set the Timer:
] 1. Press the TIMER pad_
TIMER
2. Press the INCREASE or DECREASE pad to set
the amount of time on timer,
The timer will start automatically within a few sec-
onds of releasing the INCREASE or DECREASE
pad,
The timer, as you are setting it, will display seconds
until 1 minute is reached,
Then it will display minutes and seconds until 10
minutes is reached. After 10 minutes, it will display
hours ("HR" now appears in display) and minutes
until the maximum time of 9 hours and 55 minutes
is reached.
To Reset the Timer:
tf "TIMER" is showing, press the INCREASE or
DECREASE pad until the desired time is reached.,
If "TIMER" is not showing, press the "TIMER" pad
first, then follow the instructions above to set the timer.
To Cancel the Timer:
Press the TIMER pad until the word "TIMER" quits
flashing on the display (about 4 seconds),
End of Cycle Tones
The end of cycle tone is a series of three beeps fol-
lowed by one beep every six seconds. If you would like
to remove the signal that beeps every six seconds,
press and hold the CLEAR/OFF pad for 10 seconds.
To return the signal that beeps every six seconds,
press and hold the CLEAR/OFF pad for 10 seconds.
Display Messages
If "door" appears on the display, the oven door is
open., if "LOCK" appears on the display, the oven door
is in the locked position. BAKE, BROIL and COOK
TIME cannot be set if the door is in the locked position°
23