Sears Kenmore 73611 Use, Care, Safety Manual page 47

PROBLEM
SURFACE LtGHT DOES
NOT WORK
STRONG ODOR
OVEN WILL NOT
SELF-CLEAN
OVEN DOOR WILL
NOT UNLOCK
OVEN NOT CLEAN AFTER
CLEAN CYCLE
'_DOOr', APPEARS
ON DISPLAY
CONTROL B EEPS AFTER
ENTERING OVEN TIME
OR STOP TIME
SURFACE KNOB TURNED
TO THE LITE POSITION
BUT BURNER WILL NOT
LIGHT(Sealed burner
models only)
POSSIBLE CAUSE
• Fluorescent bulb is loose or defective,. Adjust or replace.
• Switch operating light is broken. Call for service.
o improper air/gas ratio in oven. Adjust oven burner air shutters,
.An odor from the insulation around the oven liner is normal for the first few
times the oven is used. This is temporary.
- Oven temperature is too high to set self-cleaning operation. Allow the range to
cool to room temperature and reset the controls,
o Door latch handle not moved all the way to the righL
-Oven must cool below locking temperature clean cycle is complete. Do not
lock door with door latch except when using self-clean feature or the oven
may lock.
o Oven controls not set properly. Review Operating the Self-Cleaning Oven section.
= Heavily soiled ovens require 3½ to 4 hour clean time_
• Heavy Spillovers should be cleaned up before starting clean cycle°
o Self-cleaning cycle has been selected but latch handle was not moved all the
way to the righL Move the latch handle.
°Latch handle was moved to the right but a program other than self-cleaning
was selected. Move the latch handle to the right only when setting self-clean-
ing cycle°
o This is reminding you to enter a bake temperature (see the Baking section)_
= Surface knob not moved far enough into the LITE position. Move knob further
into the LITE position to allow gas to flow to the burner.
47