Operation - Zenoah EBZ7500 Operator's Manual

8.

Operation

CONTROL ARM [EBZ7500]
• Hold the upper end of the control arm in hand and,
while pulling it away from the unit, rotate arm for-
ward (anti- clockwise as the arrow direction) until it
clicks. (The first position)
And if you want, you can rotate arm more forward
until it clicks. (The second position)
Choose the arm position according to your working
condition.
• To fold the arm, reverse the order.
(1)
(2)
STARTING ENGINE
IMPORTANT
• Avoid operating the blower without flexible hose.
That will reduce the cooling air and the engine
could be damaged by overheating.
1. Push the primer bulb again and again until fuel flows
out in the yellow clear tube.
2. When the engine is cool, close the choke.
(1) The First Position
(2) The Second Position
(1) Choke Lever
(2) Primer Bulb
(3) OPEN
(4) CLOSE
8. Operation
3. [EBZ7500RH]
Set the cruise control ignition switch lever (4) to the
start position.
4. Set the throttle lever (5) (EBZ7500) / cruise control
ignition switch lever (4) (EBZ7500RH) in about 1/3
open position.
EBZ7500
EBZ7500RH
(5)
5. To start, hold the top of the blower firmly with your
left hand. Pull the starter knob slowly until re-
sistance occurs, and then give it a vigorous strong
pull.
IMPORTANT
• Avoid pulling the starter rope out to its full ex-
tent and allowing the starter rope to snap back.
This will prevent premature damage to the
starter.
• Do not let a person stand near the blower or the
exhaust port.
6. Once the engine is running, gradually open the
choke if it was set closed, and let the engine run at
idle speed for a minute to warm it up.
NOTE
When the engine fails to start after several attempts
due to overchoking, open the choke and repeat pulling
the rope.
10
EBZ7500/ EBZ7500RH
(1) Full Throttle
(2) About 1/3 Open
(3) Idling
(4) Cruise Control Ignition
Switch Lever (RH)
(5) Throttle Lever