Zenoah EBZ7500 Operator's Manual page 11

EBZ7500/ EBZ7500RH
8. Operation
ADJUSTING THE SHOULDER STRAPS
Tightening:
• Pull on the end of the strap.
Loosening:
• Pull up on the lower portion of the buckle with a fin-
ger and slide the end of the strap back up to the
buckle.
EMERGENCY REMOVAL
• In an emergency, pull up on the lower portion of both
strap buckles to loosen the straps. Move yourself
away from the unit.
ADJUSTING IDLE SPEED
• The idling speed is set for 2000 rpm at the factory.
If it is necessary to adjust the idle speed, use the
adjustment screw on the top side of carburetor.
(1) Idling Adjustment
Screw
8. Operation
STOPPING ENGINE
[EBZ7500]
• Move the throttle lever to the idling position and
press the stop switch (red button). The machine has
the mechanism that once the stop button is pushed
the plug won't give off sparks until the engine stops.
[EBZ7500RH]
• Move the cruise control ignition switch lever to the
idling position and then set it to the stop position.
NOTE
If the engine won't stop when setting the ignition
switch to the stop position, close the choke lever
and stop the engine.
In this case, please repair the machine at your near-
est servicing dealer.
11
(1) Stop Switch
(1) Cruise Control Ignition
Switch Lever
(1) Choke Lever
(2) OPEN
(3) CLOSE