Zenoah EBZ7500 Operator's Manual page 5

EBZ7500/ EBZ7500RH
5. For safe operation
8. The ignition system of your unit
produces an electromagnetic
field of a very low intensity. This
field may interfere with some
pacemakers. To reduce the risk
of serious or fatal injury, per-
sons with pacemaker should
consult their physician and the
pacemaker manufacturer be-
fore operating this tool.
WORKING CIRCUMSTANCE
1. To reduce the risk of injury as-
sociated with exhaust fume in-
halation, do not operate in un-
ventilated area. The exhaust
gases contain harmful carbon
monoxide.
2. Avoid using the blower where
stable footing and balance are
not assured.
3. Never operate the machine in
high wind, bad weather, poten-
tially
when visibility is poor or in very
high or low temperatures. (Our
recommended use environment
is below 40 degrees C (104 de-
grees F).)
AVOID NOISE PROBLEM
Check and follow the local
regulations as to sound level
and hours of operations for
blower.
1. Operate power equipment only
at reasonable hours-not early in
the morning or late at night
when people might be disturbed.
Comply with times listed in local
ordinances.
2. To reduce sound levels, limit the
number of pieces of equipment
used at any one time.
3. Operate power blowers at the
lowest possible throttle speed to
do the job.
4. Check your equipment before
operation, especially the muffler,
air intakes and air filters.
explosive atmosphere,
IMPORTANT
5. For safe operation
WORKING PLAN
• When
FUEL
To reduce the risk of fire and
burn injury:
a) Handle fuel with care. It is highly
b) Do not smoke while handing
c) Do not refuel a hot engine.
d) Do not refuel a running engine.
e) Avoid spilling fuel or oil. Always
f) Move at least 10 ft. (3 meters)
g) Always store gasoline in a con-
h) Make sure the unit is properly
i) Do not use the blower near a
BEFORE STARTING THE
ENGIN
• Each time before starting the
• Before starting operation, al-
5
planning your
schedule, allow plenty of time to
rest. Limit the amount of time
over which the product is to be
used continuously to some-
where around 30 ~ 40 minutes
per session, and take 10 ~ 20
minutes of rest between work
sessions. Also try to keep the
total amount of work performed
in a single day under 2 hours or
less.
WARNING
flammable.
fuel.
wipe unit dry before using.
away from the fueling point be-
fore starting engine.
tainer approved for flammable
liquids.
assembled and in good operat-
ing condition.
fire, as aiming the blower in the
direction of a flame may cause
flammable substances to ignite.
engine, inspect the entire unit to
see if every part is in good order
and is securely tightened in
place. If any damage is found in
the fuel line, the exhaust line, or
the ignition wiring, do not use
the blower until it has been re-
paired.
IMPORTANT
ways make sure to check if
any obstacles are left inside
the volute case and net. The
obstacles may cause damage
on fan and volute case and
serious injury.
work