Zenoah EBZ8001 Owner's Manual
  1. Manuals
  2. Brands
  3. Zenoah Manuals
  4. Blower
  5. EBZ8001
  6. Owner's manual

Zenoah EBZ8001 Owner's Manual

Hide thumbs Also See for EBZ8001:
Table of Contents

Advertisement

Quick Links

See also: Workshop Manual
EBZ8001
OWNER'S MANUAL
BLOWER
EBZ8001
115335710 (001)
Original Instruction
GB-1
G
G
B
B

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the EBZ8001 and is the answer not in the manual?

Questions and answers

Related Manuals for Zenoah EBZ8001

Summary of Contents for Zenoah EBZ8001

  • Page 1 EBZ8001 115335710 (001) Original Instruction OWNER’S MANUAL BLOWER EBZ8001 GB-1...
  • Page 2 COUNCIL’S DIRECTIVE. The products referred to are : DESIGNATION : BLOWER (Back-pack garden blower) MANUFACTURER : Husqvarna Zenoah Co., Ltd. MODEL : EBZ8001 SERIAL NUMBERS DATING : 2010 and onwards (The year is clearly stated on the rating plate,...

  • Page 3: Table Of Contents

    EBZ8001 SAFETY FIRST Contents Instructions contained in warnings within this manual marked with a symbol concern critical points which must be taken 1. Parts location ..........3 into consideration to prevent possible serious bodily injury, and for this reason you are requested to read all such instructions 2.

  • Page 4: Specifications

    EBZ8001 2. Specification Model EBZ8001 Dimensions (LxWxH)** 380 x 490 x 496 Dry weight* 12.6 Fuel tank capacity liter Engine type Air cooled 2-cycle gasoline engine Displacement 71.9 Air filter 2-stage fresh flow filter system Carburetor Rotary Ignition system Digital Ignition...

  • Page 5: For Safe Operation

    EBZ8001 5. For safe operation 1. Read this manual carefully until are tingling and burning sensa- you completely understand and tions followed by loss of color follow all safety and operating and numbness in the fingers. All instructions. factors which contribute to 2.
  • Page 6 EBZ8001 line, the exhaust line, or the igni- 5. For safe operation tion wiring, do not use the blower until it has been repaired. 1. Operate power equipment only at reasonable hours-not early in the IMPORTANT morning or late at night when people might be disturbed.
  • Page 7 5. When replacing the any other a) Use rakes and brooms to loosen part, or any lubricant, always be debris before blowing. sure to use only ZENOAH prod- b) In dusty conditions, slightly ucts or products which have been dampen surfaces or use mister...

  • Page 8: Set Up

    EBZ8001 6. Set up FLEXIBLE HOSE and SWIVEL JOINT WAIST BELT 1. Connect the blower and swivel joint with flexible hose. • The waist belt is attached to the rings on the left and Clamp both ends of the flexible hose securely with right sides of the frame.

  • Page 9: Fuel

    2-cycle gasoline engine use. 2. Put fuel into the fuel tank to 80% of the full capacity. If Zenoah oil is not available, use an anti-oxidant added 3. Fasten the fuel cap securely and wipe up any fuel quality oil expressly labeled for air-cooled 2-cycle spillage around the unit.

  • Page 10: Operation

    EBZ8001 8. Operation STARTING ENGINE NOTE IMPORTANT When the engine fails to start after several attempts due to overchoking, open the choke and repeat pulling the rope. • Avoid operating the blower with the flexible tube and swivel joint disconnected. That will reduce the...

  • Page 11: Maintenance

    EBZ8001 9. Maintenance Maintenance, replacement, or repair of the emission control device and systems may be per- formed by any non-road engine repair establishment or individual. Daily Every Every Every System / Compronent Procedure 25 hours 50 hours 100 hours...
  • Page 12 EBZ8001 9. Maintenance SPARK PLUG • The spark plug may gather carbon deposits on its firing end with reasonable use. Remove and inspect the spark plug every 25 hours and clean the elec- trodes as necessary with a wire brush. The spark gap should be adjusted to .025 in (0.6~0.7mm).

  • Page 13: Storage

    EBZ8001 9. Maintenance AIR INLET NET HARNESS • If the harness is damaged it may break during use, IMPORTANT thus causing the product to fall and resulting in per- sonal injury. Follow the instructions below to replace • Blowing air is taken in from the air inlet net. When air the harness with new one.

  • Page 14: Troubleshooting Guide

    → clogged with dust → clean When your unit seems to need further service, please consult with our ZENOAH service shop in your area. Limited warranty Should any failure occur on the product under normal oper-...

Table of Contents