Plugging Of The Thermostat; Installation Of The Appliance - J. A. Roby ULTF Instruction Manual

-To plug the thermostat, unscrew the junction box (C) on the side of the furnace (See
page 19 fig.10). Join the black wire of the thermostat with the black one of the
thermostat junction box, then insulate them with a wire nut. Join the white wire of the
thermostat junction box to the white one of the thermostat, and then insulate them with a
wire nut. Reinstall the junction box on the furnace.
Fan controller:
Auto: The fan will start automatically. Put the lever at Auto
position during the heating seasons.
Man: Start the fan manually. To stop the fan, put the lever
back in position Auto.
Plenum and fan control module
1. Put the plenum (E) on the
appliance with 12 screws.
Make sure the plenum
hole (C) is oriented to the
right of the appliance
(looking from the front).
Install the fan control
module (D).
PR_I019/2020-11-16-EN

PLUGGING OF THE THERMOSTAT

INSTALLATION OF THE APPLIANCE

FIGURE 6
Revision: 5
FIGURE 5
17