Fans
2. Open up the access hatch
(F) by removing the 3
screws (E)
3. Remove the 2 blower
panels (D)
4. Put your hand inside the
access hatch (F) and put 8
screws in place (A). Fasten
the blowers (C) with the
nuts (B) (see figure 13)
5. Unscrew the 8 screws (A) on the left side of the casing (looking from the back of the
appliance)
6. Remove the panel and put the first fan power supply into the cable gland (B)
7. Insert the cable gland with the wire inside the space provided for this purpose
8. Put back the panel with the cable gland and the 8 (A) screws
PR_I019/2020-11-16-EN
Figure 7
Revision: 5
18