Preventive Measures And Maintenance - J. A. Roby ULTF Instruction Manual

PREVENTIVE MEASURES AND MAINTENANCE

• Verify the accumulation of creosote every week that you use the appliance
until you know at which frequency it must be cleaned (minimum once per
year). Remove every creosote deposit in order to prevent chimney fires.
• Cleaning of heat exchanger, vent connector of chimney and induced draft
fan (if applicable) is particularly important at the end of each winter in order
to remove corrosion which was made during summer and caused by the
ash accumulation. It must be in good condition all the time.
• To clean the heat exchanger, remove the bricks placed at the upper part in
the firebox, clean and replace them. Do not remove stainless steel pipes.
• Verify regularly the vent connector, gaskets and sealing materials to make
sure that smoke and gas from the combustion are not absorbed and
conveyed in the air distribution system.
• Do not alter or modify the air intakes of the appliance to get a stronger fire.
• To clean the glass, J.A. Roby Inc. recommends to use products for this
purpose or an oven cleaner. Avoid cleaning when the glass is hot and
using abrasive.
PR_I019/2020-11-16-EN Revision: 5 25