Clean-Up Procedure; Lighting - J. A. Roby ULTF Instruction Manual

1. Remove the finishing plate (A).
2. Remove the clean-up plate (D)
by taking out the 13 screws
(C).
3. Clean-up the inside of the heat
exchanger using an
appropriate brush and vacuum
cleaner.
4. Put back the clean-up plate
and screw back the screws so
that everything is air-tight
against the fiber glass gasket.
Be careful not to overtighten
the screws so that it will create
leaks (Part number for a
replacement gasket: V125 X
8MM).
5. Put back the finishing plate.
Now that you have completed the installation of the appliance according to the
recommendations, you are ready for the lighting!
1. Place papers and small wood in the appliance.
2. Before lighting, be sure that the chimney is warm enough.
3. When the fire is well lit, gradually add bigger logs until an ember bed is formed.
Do not charge the appliance over the level of firebricks
PR_I019/2020-11-16-EN

CLEAN-UP PROCEDURE

LIGHTING

Revision: 5
FIGURE 20
.
26