Page 1
Heavy Duty Tilting TV Wall Mount Model: QG-TM-091-BLK For Most 60" to 100" Flat Panel and Curved TVs Do not exceed the maximum rated weight 100kg 100kg (220lbs) (220lbs) specified. Otherwise, serious injury or RATED RATED property damage may occur.
Page 2
200 x 200, 300 x 200, 300 x 300, 400 x 200, 400 x 300, 400 x 400, 600 x 400, 600 x 600, 800 x 400, 800 x 600, 800 x 800, 1000 x 400, parts, please send us an email at support@qualgear.com or 1000 x 600, 1000 x 800...
Before starting installation, please check that all parts shown in this checklist IMPORTANT: are included. If any parts are missing or damaged, contact your local distributor or support@qualgear.com for replacement parts and do not start assembly and installation WARNING until you receive all the parts.
Page 4
Installing the Plastic Knob 90mm 90mm ( 3.5" ) 3.5" ø 6 mm (ø 1/4") Q G -T M -0 9 1 -B L K Plastic Knob Using the marking template (E) provided, Using a power drill and 1/4" drill bit, drill mark four holes for drilling on the centerline of pilot holes of 1/4"...
Page 5
Mounting to a Concrete Wall NOTE Do NOT use power drill and do NOT over tighten the lag bolts. Marking Template Bubble Level Q G -T M -0 9 1 -B Hold the marking template (E) provided against the wall where you want to install your TV, Wall Plate mark six holes for drilling.
Page 6
Installing to a Flat Back Panel of a TV M-A/ M-B Flat Back 5.5mm Panel Adapter Bracket Adapter Bracket M-C/ M-D 8.5mm Choose the appropriate screws and washers according to the type of your TV, and attach adapter brackets (B and C) to the back of the TV using a Phillips screwdriver.
Page 7
Installing to a Curved or Recessed Back Panel of a TV Choose the appropriate screws, washers, and spacers (if necessary) according to the type of your T V and attach adapter brackets (B and C) to the back of the TV using a Phillips screwdriver. 8.5mm IMPORTANT! Tighten all screws but...
Page 8
Removing the TV from the Wall Plate Using an assistant, hang the TV onto the wall plate carefully by pushing the buttom of the TV towards the wall until the latches fit into the wall plate rail. Then hide the two safety straps at the back of the TV to avoid pulling on it accidently, which may cause the TV to release and fall.