Page 1
QG-DB-001-BLK Product Dimensions SINGLE SHELF WALL MOUNT Scan the QR Code™ below for more info about this product: Scan the QR Code™ +1 (972) 423-8960 support@qualgear.com below to contact us: Do not exceed the maximum rated weight (17.6lbs) (17.6lbs) specified. Otherwise, serious injury or facebook.com/qualgear...
If any parts are missing or damaged, contact your local distributor or WARNING support@qualgear.com for replacement parts and do not start assembly and installation until you receive all the parts. Do not begin to install your QualGear product Tighten screws firmly, but do not over tighten.
Page 3
Mounting to a Wooden Stud Wall Wall Plate For concrete wall NOTE mounting, follow Step 1b. Stud Finder Using an edge-to-edge stud finder, find the Using a level, mark the centerline of the stud. edges of the stud. 50mm 50mm (2") (2") Mount the wall plate (C) and tighten it with the provided...
Page 4
Mounting to a Concrete Wall NOTE Do NOT use power drill and do NOT over tighten the lag bolts. Wall Plate Marking Template QG -DB -00 1-B Hold the marking template (F) provided against the wall where you want to install your AV equipment, mark two holes for drilling.
Page 5
Assembling the Glass Holder and the Connecting Piece Tighten screws until Connecting Piece NOTE 3mm of space is Glass Holder between part D and B At the desired location, use the Install the connecting piece (D) to the glass holder (B). allen key to tighten the screws until the glass holder is secured.
Page 6
Cable Management (AV equipment not included) If adjustment is necessary, loosen screws P-C with Allen key P-F, slide the glass holder to the desired position then tighten screws again to secure. Installing the Glass Shelf Glass Shelf Glass Holder Place the glass gently on the mounted glass holder. Run the cable through the cable clips. Attach the glass shelf to the glass holder using the screw and the plastic bush.