Page 1
QG-KIT-CA-3IN-W Hanging the Projector Assembly onto the Projector Plate PROJECTOR MOUNTING KIT Projector Plate Projector Mount Click! Slide projector assembly into the projector plate until you hear a click. Allen Key (H) Scan the QR Code™ below Projector for more info about this product:...
Before starting the installation, please check that all parts shown in this checklist are included. If any parts are missing or damaged, contact your local distributor or support@qualgear.com for replacement parts and do not start assembly and installation WARNING until you receive all the parts.
Page 3
Mounting to a Wooden Joist or Wooden Stud Ceiling For concrete ceiling mounting, NOTE follow step 1b. Stud Finder Using a power drill and a 5/32" wood drill bit, drill holes of 5/32" (4mm) diameter, and 2.5" (65mm) depth at the marked locations. Using an edge-to-edge stud finder, find the Using a straight edge, mark the centerline edges of the stud.
Page 4
Mounting to a Concrete Ceiling Make sure that the drilled holes are free of dust for proper installation of anchors. Metal Expansion Anchor (G) Using wall marking template (B), mark on the concrete the locations of where you want to mount the ceiling adapter.
Page 5
Connecting the Pipe to the Projector Plate Installing the Pipe and Decorative Cover To connect the 3-Inch NPT pipe (D) to the projector plate, twist the male threaded end of the pipe into the female To connect the 3-Inch NPT pipe to the mounted adapter plate, twist the male threaded end to thread on the projector plate.
Page 6
Making Adjustment for Mounting Attaching the Projector Mount to the Projector Screws (O/P/J/Q) Allen Key (H/ I) Washers (K) For screws (O or P) only Projector Extension Brackets (not included) Allen Key (H) Allen Key (H) Use washers (K) for screws (O or P) only. NOTE Depending on your projector, use the appropriate screws (O/P/J/Q) and then Extension Brackets...