Handling With Long Rubber Grippers (Wb-G-120) - probst FTZ-MULTI-15 Operating Instructions Manual

Operation
1)
Otherwise there may be faulty switching and when setting down the load this can cause deformation or
damage of the automatic release!
The jerky lifting and lowering of the device with and without load. e.g. caused through driving fast with the
lifting equipment/carrier over uneven grounds is forbidden
When replacing a defective automatic release, it is
essential to ensure that the slots of the two
clamping pins always point downwards.
The position of the slots must not be above or
center, otherwise there is a risk that the
automatic release may jam when switching!
6.2.1

Handling with long rubber grippers (WB-G-120)

Only complete layers of stones may be handled→ see Fig. B
Do not lift any components off-centre or handle non-complete layers of stones → see Fig. A
The device (FTZ-multi 15) could be damaged while gripping or the gripping goods could fall down!
Fig. A
53100348
Fig. B
19 / 26 GB