Omron SYSMAC C Series User Manual page 34

Using the programming console
Remember that the coil and the time value for the contact keyed in for
address 0005 must stil! be specified. This is done by keying in
poaz
for address 0008.
This message is displayed asking for the timer data. Since the data
includes a decimal point before the last digit, to set a value of 2 seconds,
we enter
C
^o | WRITE
The only thing that remains is to complete the circuit by specifying the
output. Do this by entering
OUT
e
The output relay number for this output is 0500, which is automatically
selected by the PC. (Remember that 05xx is the output channel
designation, while 00xx is the input channel designation. The relay
number is xx.)
The final instruction in our program is the END instruction, which tells the
PC that the program is complete. Writing this requires the use of the FUN
key and the value 01 which represents the END instruction. So key in
ral) oe
and you're finished.
Now check your program
To check whether the program has been correctly written, go back
through it using the arrow keys to scan what you've done. If you see you
need to make corrections, just overwrite the statements that are in error.
Deletion and insertion of instructions is explained next.