Related Manuals for BDI CORA 1176
Summary of Contents for BDI CORA 1176
- Page 1 CORA ™ 1176 END TABLE INSTRUCTION MANUAL LET’S GET STARTED. DESIGN MATTHEW WEATHERLY...
- Page 2 Congratulations on the purchase of your Cora End Table from BDI. Your end table has been designed to provide a lifetime of enjoyment. This manual will provide assembly instructions and other helpful information to ensure you get the most out of your product.
- Page 3 HARDWARE AND COMPONENTS Unpack and identify the parts listed below. The assembly workspace should be a non-marring surface, such as carpet. For missing hardware pieces, please contact BDI Customer Service at customerservice@bdiusa.com. For all other concerns, please contact your BDI retailer.
- Page 4 SCREW – H1 Attach the 4 Shelf Supports (C4) to the 2 Legs (C3) using 4 Screws (H1) in the orientation shown. Tighten screws with Hex Wrench (T1). SCREW – H2 Partially thread screws into these holes 4 | BDIUSA.COM CORA 1176...
- Page 5 STEP 3. ATTACH LEGS TO BASE ASSEMBLY Slide the Screws in the Legs (C3) into the slots in the Connection Plates (C1). Thread the remaining 4 Screws (H2) into the holes in the Legs (C3). HEX WRENCH – T1 Tighten all screws with Hex Wrench (T1). SCREW –...
- Page 6 STEP 5. ATTACH BASE ASSEMBLY TO END TABLE CASE Attach the Base Assembly to the End Table Case (C6) with 4 Screws (H4). Tighten with Hex HEX WRENCH – T1 Wrench (T1). SCREW – H4 6 | BDIUSA.COM CORA 1176...
- Page 7 STEP 6. INSTALL DRAWER PULL ASSEMBLY Carefully flip the table onto its base. Open the NOT INCLUDED drawer and install the Drawer Pull (C7) using PHILLIPS SCREWDRIVER 2 Wood Screws (H5). Tighten with Phillips Head Screwdriver (not included). SCREW – H5 NEED ASSISTANCE? customerservice@bdiusa.com | 7...
- Page 8 PRODUCT REGISTRATION Registering your new BDI product allows us to send you important product updates, service information, and helpful hints related to your BDI products. Register today, and you will be entered to win free a BINK table from BDI: www.bdiusa.com/register These distinctive product configurations are protected by US and international patents, trade dress, and/or copyright laws.
Need help?
Do you have a question about the CORA 1176 and is the answer not in the manual?
Questions and answers