National Instruments FieldDAQ FD-11601 User Manual page 42

Synchronizing analog input FieldDAQ devices with NI-DAQmx in LabVIEW
■
—Visit ni.com/info
Designing Ethernet measurement systems for synchronization, considering
■
topologies, masters, and third party devices—If topology changes result in a
device's master changing, executing tasks may be affected. Visit
and enter fdenet.
How to achieve high accuracy measurements—Visit
■
fdsync.
Synchronization accuracy explained—Visit
■
Synchronizing FieldDAQ and TSN-Enabled Ethernet cDAQ Chassis to a
■
PXI System—Visit
Ethernet Ports and Networking
The Ethernet Network Interface transfers data between the FieldDAQ device and the
network. It gathers the data into TCP/IP packets that can be sent across the network
and interpreted by the host.
Note
Refer to
Time Controller
host computer or host real-time controller.
Ethernet Ports
The FieldDAQ device has two 8-pinX-coded M12 Ethernet ports—0 and 1. You
can use a shielded straight-through Ethernet or an Ethernet crossover cable with
either of the Ethernet ports to network your device to a computer host, NI Linux
Real-Time controller, another FieldDAQ device, or any network connection on the
same subnet. Refer to
ports in various topologies.
42
ni.com
and enter fdaisync.
ni.com/info and enter fd1588.
Setting up the FieldDAQ Device
for information about connecting the FieldDAQ device to a
Topology Options for more information about using these
FD-11601 Feature Usage
ni.com/info
ni.com/info and enter syncacc.
or Connecting to a Real-
ni.com/info
and enter