Tsun TSOL-MS400 Quick Installation

MICROINVERTER
Quick Installation
When choosing the position of installation, comply with the following
conditions:
sunlight.
may be present.
·
correct operation of electronic equipment.
Installation Steps
DANGER
clearances.
incorrect installation and operation may lead to serious safety and
shock hazards or equipment damage.
Be aware that installation of this equipment includes risk of electric
shock.

Step 1. Make an installation map

CAUTION
·If there are more than one installation site, please make the
installation site.
The direction on the upper left corner means the actual installation
orientation.
Take out the SN labels and installation map from the package. Paste
the SN labels on the installation map as below and complete the
information of the solar plant.
TSOL- MS400/MS350/MS300
TSOL- MS1600/MS1800/MS2000
and humid.
G3
·There are no screws and nuts in the package.
length of AC cables. The length of AC cables are shown as below:
Model
TSOL-MS1600/MS1800/MS2000
TSOL-MS800/MS700/MS600
TSOL-MS400/MS350/MS300
Choose an installation position. Using two pairs of screws and nuts
microin
TSOL- MS800/MS700/MS600
DANGER
WARNING
CAUTION
Cable Length
2.5 m
2.5 m
1.4 m

Step 3. Connect the ground cable

WARNING
·Ensure that all
·Use φ6 screw for .

Step 4. Connect the AC cable of two microinverters

WARNING
Model Quantities for each cable section
TSOL-MS2000/MS1800/MS1600
TSOL-MS800/MS700/MS600
TSOL-MS400/MS350/MS300
AC cables.
branch circuit.
connector to be closed.
2 / 2 / 3
5 / 6 / 7
11 / 13 / 15