Nikon ECLIPSE E400 POL Instructions Manual page 30

Assembly
e
WARNING
To prevent electrical shock or fire, turn off the power switch (flip it to the
side) during assembly.
CAUTION e Be careful not to pinch your hands or fingers when setting up the microscope
e Viewing will be adversely affected if any of the lenses is scratched or has
fingerprints on it, Handle the lenses carefully during assembly
© This microscope is a precision optical instrument. Handle it carefully and do
not subject it to a strong physical shock. (The accuracy of the objectives in
particular may be adversely affected by even a weak physical shock.)
Assemble each part in sequence as numbered in the diagram. (For details, refer to pages 29 to 33.)
Tools needed
* A hexagonal screwdriver (provided with the microscope) 1.3 mm
When not using. place it in the tool holder in the back of the microscope.
Installation location
This product is a precision optical instrument, and using or storing it under unsuitable
conditions may damage it or may have an adverse effect on its accuracy. The following
conditions should be kept in mind when selecting the installation location.
* Avoid installing the microscope in a brightly lit location such as a room that receives direct
sunlight, or directly under room lights. The quality of the view through the microscope
deteriorates if there is excessive ambient light.
* Install the microscope in a location that is free from dust or dirt.
* Install the microscope on a flat surface with little vibration.
© Install the microscope on a sturdy desk or table that is able to bear the weight of the
instrument.
* Do not install the microscope in a warm, humid location (environmental temperature: 40°C or
higher and relative humidity: 60% or more).
28