Sanuvox VP900 INTERCEPTOR Instruction Manual

Air purification unit for vehicles
Hide thumbs Also See for VP900 INTERCEPTOR:

Advertisement

Quick Links

REGISTER
YOUR WARRANTY
READ AND SAVE THESE SAFETY INSTRUCTIONS BEFORE USING THIS PRODUCT.
Read and follow all instructions contained in the manual before using the product. Read the maintenance instructions before opening the UV unit
or system. Failure to comply with these instructions may result in injuries or damage to the UV unit or system.
1.
Installation and servicing of UV units or systems (in an
air conditioning system or not) can be hazardous. Only
trained and qualified service personnel should install,
repair or service equipment.
Untrained personnel can perform basic maintenance
2.
functions such as replacing lamp(s) and/or filter(s). All
other operations should be performed by trained service
personnel.
3.
The unit is not to be used by persons (including children)
with reduced physical, sensory or mental capabilities, or
lack of experience and knowledge.
CAUTION: Unit is not a toy. Keep away from
unsupervised children. Do not leave children unattended
with the unit.
4.
DO NOT hang onto the UV unit or system.
5.
Some UV units or systems could be heavy: Make sure
you have a minimum of 2 people to safely move or install
these UV units or systems, and make sure you adopt the
most ergonomic position possible (use UV unit or system
handles, if applicable).
CAUTION: Installing or maintaining heavy equipment,
especially overhead, can cause back pain or other injuries.
6.
When installing or servicing an overhead UV unit or system,
be careful not to fall off the stepladder. Furthermore, make
sure the UV unit or system latches are always in place to
prevent falling parts.
CAUTION: Some parts of some UV units and systems
may open suddenly if the UV unit or system is installed
high up without its locks.
7.
Units that are obviously damaged must not be operated.
8.
CAUTION: When working on the UV unit or system,
observe precautions on the literature, tags and labels
attached to the UV unit or system, and all other safety
precautions considered as best practices in the HVAC
industry, if applicable.
Installation Date: _______________
Installer Contact Info.: _________________________________________
VP900 INTERCEPTOR
AIR PURIFICATION UNIT FOR VEHICLES
Medical Model

IMPORTANT SAFETY INSTRUCTIONS

NEVER EXPOSE EYES OR SKIN TO AN OPERATING UV LAMP.
9.
When applicable, local regulation may comprise more
restrictive installation and/or certification requirements.
The aforementioned requirements prevail on those of this
document and the installer agree to conform to these at his
own expense.
10. Follow all the safety instructions outlined in this document
and respect all local and national codes applicable.
11. All UV units or systems contain a UV-C source. Damage to
the housing or unintended use of the UV unit or system may
result in harmful UV-C leaks. UV-C may, even in little doses,
cause harm to the eyes and skin.
12. Never expose eyes or skin to an operating UV lamp.
Therefore, before installing or performing maintenance
on the UV unit or system, TURN OFF AND DISCONNECT
the UV unit or system from all power sources (there
may be more than one switch to disconnect) and also
disconnect the HVAC system, is applicable.
CAUTION: Electrical shock may cause injuries or
possibly death. FIRST AID INSTRUCTIONS: If injured,
consult a doctor.
12.1. To reduce the risk of electric shock, this equipment has a
grounding type plug that has a third (grounding) pin. This
plug will only fit into a grounding type power outlet. If the
plug does not fit into the outlet, contact qualified personnel
to install the proper outlet. Do not alter the plug in any way.
13. UV rays may damage certain types of filters (polymer or
plastic); please keep the UV unit or system light away from
shining directly on plastic.
14. When installing or performing maintenance on the UV unit
or system, it is recommended to wear safety gloves. In
order to avoid reduced performance of lamp(s), do not
touch lamp glass without gloves.
Sanuvox Technologies Inc, © 2019 All rights reserved. September 2023 EN v.1
15. Just like conventional fluorescent lamps, UV lamps contain
a small quantity of mercury: if a lamp breaks, clean and
dispose of with care. UV lamps can be disposed/recycled
after use in the same way as any other fluorescent lamps.
Contact and follow the specific instructions of your local
and national authorities.
15.1. Dispose of unit or system according to the specific
instructions and standards of your local and national
authorities.
16. Use only specified SANUVOX branded replacement
UV lamps for your UV unit or system. Use of any other
lamps will void your warranty and can result in damage to
the UV unit or system.
17. Sanuvox UV units or systems are not waterproof. DO NOT
INSTALL OUTDOORS OR IN WET LOCATION unless
specified otherwise.
18. Use of this unit or system supplements, but does not
replace, infection control best practices. Users must follow
all these practices, particularly with regard to cleaning and
disinfecting surfaces.
For any inquiries on a UV unit or system, contact :
Installed by: _________________
Instruction Manual
SAVE THESE INSTRUCTIONS
Robert Smith
146 Barr St, Saint-Laurent
Quebec, CA, H4T 1Y4
1-888-726-8869
techsupport@sanuvox.com

Advertisement

Table of Contents
loading

Summary of Contents for Sanuvox VP900 INTERCEPTOR

  • Page 1: Important Safety Instructions

    UV unit or system, and all other safety precautions considered as best practices in the HVAC industry, if applicable. Installation Date: _______________ Installed by: _________________ Installer Contact Info.: _________________________________________ Sanuvox Technologies Inc, © 2019 All rights reserved. September 2023 EN v.1...
  • Page 2: Table Of Contents

    Instruction Manual for VP900 Interceptor TABLE OF CONTENTS IMPORTANT SAFETY INSTRUCTIONS TABLE OF CONTENTS ABOUT THE PRODUCT COMPONENTS How it Works SETUP & INSTALLATION What you will need What’s included Step by Step Setup & Installation OPERATION How to Operate your Product...
  • Page 3: About The Product

    COMPONENTS How it Works Contaminated air enters the VP900 Interceptor parallel to the UV ‘J’ lamp, thus increasing contact time with the UV energy. The UV lamp attacks biological contaminants. Finally, the purifed air circulates through the vehicule. A. Air outlet B.
  • Page 4: Setup & Installation

    CAUTION: Handle your product with care to avoid breaking parts. Make sure you have a free and safe space to unpack, install and setup your product. Confirm you have access to the necessary power source for the product requirements (see unit or system label). If you have any questions regarding the installation instructions, call SANUVOX at 1-888-726-8869. What’s included The VP900 Interceptor with its UV lamp and a basic installation kit.
  • Page 5: Operation

    OPERATION How to Operate your Product The VP900 Interceptor is an automatic unit: once it’s installed and plugged in, simply press the power switch to turn it ON and enjoy clean air! CAUTION: The suggested operating temperature range is 10 to 50°C (50 to 122°F). Operating the VP900 Interceptor outside this range will result in decreased performance.
  • Page 6 Instruction Manual for VP900 Interceptor STEP 7 6. Insert the new lamp. Be sure to wear cotton gloves guaranteeing a clean lamp free from fingerprints. 7. Lift the lamp clamp lever so that it is perpendicular (at 90°) to the lamp.
  • Page 7: How To Clean Your Product

    Instruction Manual for VP900 Interceptor How to Clean your Product For optimal performance, the lamp(s) and filter(s) should be kept free of dust and residue deposit. Clean when necessary with mild soap or alcohol. To clean the unit exterior, use a damp cloth with general purpose detergent. Always spot test the cleaner to make sure it does not damage the surface.
  • Page 8: Storage

    (DNA/RNA) of microorganisms, which inactivates them. Unlike conventional UV lamps on the market, Sanuvox units and systems use a patented process that delivers a maximum dose of UV to the moving air stream or surfaces. CAUTION: Never expose eyes or skin to an operating UV lamp.
  • Page 9: Step By Step Uv Lamp Continuity Test

    Instruction Manual for VP900 Interceptor A. Step by Step UV Lamp Continuity Test STEP 1 1. Take the VP900 Interceptor out of its intallations and open the lamp acces door. STEP 2 2. Remove the UV lamp from the lamp socket by opening the retaining clamp and pulling the UV lamp out of the reflector chamber.
  • Page 10: Warranty

    This warranty applies only to the original purchaser of this product from the original date of purchase. At its option, SANUVOX will repair or replace this product if it is found to be defective in material or workmanship.

Table of Contents