Table of Contents
Advertisement
STORAGE
The VP900 Interceptor does not require specific storage. It is a unit that works continuously when ON.
CAUTION: Keep away from unsupervised children. This unit is not a toy.
ULTRAVIOLETS
Ultraviolet wavelengths (UV) emitted by Sanuvox units and systems are identical to ultraviolets produced by the sun. UVC
damage nucleic acids (DNA/RNA) of microorganisms, which inactivates them. Unlike conventional UV lamps on the market,
Sanuvox units and systems use a patented process that delivers a maximum dose of UV to the moving air stream or surfaces.
CAUTION: Never expose eyes or skin to an operating UV lamp.
ELECTRICAL RATINGS, POWER CONSUMPTION & AVAILABLE VOLTAGE
The VP900 Interceptor has a power consumption of 25W.
The product is rated at 120V to 240V, and 50 Hz to 60 Hz.
See product label to confirm power consumption of your specific unit or system.
NOTE: IF YOU EXPERIENCE A PROBLEM, PLEASE CONTACT CUSTOMER SERVICE FIRST OR SEE YOUR WARRANTY.
DO NOT RETURN THE PRODUCT TO THE ORIGINAL PLACE OF PURCHASE. DO NOT ATTEMPT TO OPEN THE
PRODUCT OR TAMPER WITH ITS COMPONENTS WITHOUT CONTACTING CUSTOMER SERVICE FIRST. DOING SO
MAY VOID YOUR WARRANTY AND CAUSE PERSONAL INJURY OR DAMAGE TO THE PRODUCT.
TROUBLESHOOTING
If your product is not working properly, refer to the following.
What you will need
A Phillips No. 2 screwdriver, a non-magnetic 5/16" nutdriver and spare parts.
Problem
Unit comes ON, but lamp is OFF: its
"glow" isn't visible throught the oulet
louver.
Unit doesn't come ON.
Unit comes ON and lamp is ON, but the
motor is not turning or is making rattling
noise.
Contact your contractor for all your needs in terms of replacement parts:
8
Possible Cause
- Lamp and/or ballast are defective.
- There is no power to the electrical outlet.
- The On/Off switch is not ON.
- The power cord is damaged.
- The micro switch / cut-off switch is not well
engaged.
- Motor is defective.
- Motor wire connection is not properly
connected.
power cord, UV lamp, ballast, grill, fan motor, etc.
Instruction Manual for VP900 Interceptor
Solution
- Check lamp continuity.
See UV Lamp Continuity Test
instructions on page 9 (A).
- Get a genuine replacement lamp and/or
ballast.
- Replace lamp and/or ballast.
- Make sure the power outlet is working.
- Make sure the unit is plugged in to 120V
outlet.
- Push the ON button on the display.
- Replace power cord.
- Make sure the lamp door is well closed.
- Make sure the lamp door pin pushes on
the micro switch / cut-off switch.
- Replace motor.
- Check motor wire connection.
www.sanuvox.com
1-888-726-8869
Advertisement
Table of Contents
