Sanuvox P900-GX Instruction Manual

Sanuvox P900-GX Instruction Manual

Portable uv air purifier, residential

Advertisement

REGISTER
YOUR WARRANTY
ONLINE AT
www.sanuvox.com
READ AND SAVE THESE SAFETY INSTRUCTIONS BEFORE USING THIS PRODUCT.
Read and follow all instructions contained in
this manual before using the product. Failure
to comply with these instructions may result
in personal injuries or damage to the unit or
system.
1. Installation and servicing of air conditioning
and related equipment can be hazardous due
to systems pressure and electrical components.
Only trained and qualified service personnel
should install, repair or service equipment.
2. Untrained personnel can perform basic
maintenance functions such as replacing
lamp(s) and/or filter(s). All other operations
should be performed by trained service
personnel.
3. When working on the unit or system, observe
precautions in the literature, tags and labels
attached to the unit or system, and all other
safety precautions considered as best practices
in the HVAC industry.
Installation Date: _______________
Installer Contact Info.: _________________________________________
P900-GX
PORTABLE UV AIR PURIFIER
Residential Model

IMPORTANT SAFETY INSTRUCTIONS

4. When
applicable,
comprise more restrictive installation and/or
certification requirements. The afore mentioned
requirements prevail on those of this document
and the installer agrees to conform to these at
his own expense.
5. Follow all the safety instructions outlined in this
document and respect all local and national
codes applicable.
6. Never expose eyes or skin to ultraviolet light
from any source. Therefore, before installing
or performing maintenance on the unit or
system, TURN OFF AND DISCONNECT the
unit or system from all power sources (there
may be more than one switch to disconnect).
CAUTION: Electrical shock may cause
personal injuries or possibly death.
7. UV rays may destroy certain types of filters
(polymer or plastic); please keep the unit or
system light away from shining directly on
plastic.
Sanuvox Technologies Inc, © 2019 All rights reserved. February 2020 EN v.1
local
regulation
may
8. When installing or performing maintenance on
the UV unit or system, it is recommended to
wear safety glasses and gloves. In order to
avoid reduced performance of lamp(s), do not
touch lamp glass without gloves.
9. UV lamps contain a small quantity of mercury:
if a lamp breaks, clean and dispose of with
care. UV lamps can be disposed/recycled after
use, as any other fluorescent lamps. Contact
and follow your local and national authorities'
specific instructions.
10. Use only specified SANUVOX branded
replacement UV lamps with your unit or
system. Use of any other lamps will void your
warranty and can result in damage to the unit,
system and/or lamp(s).
11. Most UV units or systems are not waterproof.
DO
specified otherwise.
Installed by: _________________
Instruction Manual
NOT
INSTALL
OUTDOORS
SAVE THESE INSTRUCTIONS
unless

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the P900-GX and is the answer not in the manual?

Questions and answers

Summary of Contents for Sanuvox P900-GX

  • Page 1: Important Safety Instructions

    SAVE THESE INSTRUCTIONS in the HVAC industry. plastic. Installation Date: _______________ Installed by: _________________ Installer Contact Info.: _________________________________________ Sanuvox Technologies Inc, © 2019 All rights reserved. February 2020 EN v.1...
  • Page 2: Table Of Contents

    Instruction Manual for P900-GX TABLE OF CONTENTS IMPORTANT SAFETY INSTRUCTIONS TABLE OF CONTENTS ABOUT THE PRODUCT COMPONENTS How it Works SETUP & INSTALLATION What you will need What’s included Step by Step Setup & Installation Step by Step Stand Installation...
  • Page 3: About The Product

    How it Works Contaminated air enters the P900-GX parallel to the UV ‘J’ lamp, thus increasing contact time with the UV energy. First, the air goes through an inlet filter that captures particles. After, the UVV oxidizing section of the lamp destroys chemicals and odors, the UVC germicidal section of the lamp destroys biological contaminants.
  • Page 4: Setup & Installation

    See Stand and Handle Installation instructions on page 5. STEP 3 3. Replace the P900-GX upright or on wall and plug the purifier in a wall outlet. You are now ready to power ON your new P900-GX and enjoy great air quality for you and your family.
  • Page 5: Step By Step Stand Installation

    Instruction Manual for P900-GX Step by Step Stand Installation STEP 1 1. Loosen the two bottom screws between the two rubber feet. STEP 2 2. Slide the stand through the two screws and tighten. Step by Step Handle Installation STEP 1 1.
  • Page 6: Operation

    OPERATION How to Operate your Product The P900-GX is an automatic unit: once it’s installed and plugged in, simply press the power switch to turn it ON and enjoy clean air in your home! CAUTION: The suggested operating temperature range is 10 to 50°C (50 to 122°F). Operating the P900-GX outside this range will result in decreased performance.
  • Page 7: Step By Step Adjust Fan Speed

    How to Replace Lamp(s) Replacing lamp on the P900-GX is quick and easy. Simply turn off the power source, remove and dispose of old lamp, replace with new Sanuvox branded UV lamp, turn power source back on. See below for detailed step by step instructions.
  • Page 8 It may be necessary to rotate the plug 90° to attach it. STEP 8 8. Replace the lamp access door and secure it with its 4 screws. STEP 9 9. Replace the P900-GX upright or on wall and plug the purifier in a wall outlet. www.sanuvox.com 1-888-726-8869...
  • Page 9: How To Clean Your Product

    Instruction Manual for P900-GX How to Clean your Product For optimal performance, the lamp(s) and filter(s) should be kept free of dust and residue deposit. Clean when necessary with mild soap or alcohol. To clean the unit exterior, use a damp cloth with general purpose detergent. Always spot test the cleaner to make sure it does not damage the surface.
  • Page 10: Storage

    ULTRAVIOLETS: UVV & UVC The UVC (254 nm) and UVV (185 nm) light produced by Sanuvox UV units and systems are the same two UV wavelengths produced by the Sun. The UVC wavelength attacks the micro-organisms on a molecular level deactivating and destroying the contaminants, while the UVV wavelength degrades the chemicals and odors.
  • Page 11: Step By Step Verification Of Motor Wire Connection

    TURN OFF AND DISCONNECT the unit or system from all power sources. STEP 2 2. On the back of the P900-GX, unscrew the 8 screws along the sides (4 on the left, and 4 on the right) to open the unit. STEP 3 3.
  • Page 12: Warranty

    This warranty applies only to the original purchaser of this product from the original date of purchase. At its option, SANUVOX will repair or replace this product if it is found to be defective in material or workmanship.

Table of Contents