Table of Contents
Advertisement
DX2
Series
1.0
Introduction
Overview
The intent of this manual is to provide information regarding general safety, installation, operation and
maintenance of the tube heater. You must read and understand the instructions and safety warnings in
this manual before installing the tube heater. Additional literature on this and other products is available
at www.brantradiant.com.
Heater Components*
Prior to installation, verify that the heater's gas type and voltage (as listed on the rating plate) match that of
your application. Also verify that you have received all heater contents included with your tube heater.
Refer to the last page for a list of the kit contents for your model heater. Materials not included in the
heater kit contents (e.g., screws, vent material, terminals, etc.) are the responsibility of the installer. Notify
your product representative or Brant Radiant Heaters Ltd. of any discrepancy or missing kit contents prior
to installing unit.
Figure 1.1
•
Heater Components *
Reflector Center Support
Tube Hanger
Reflector End Cap with Clips*
Burner Control Box
16" Burner Tube
Flexible Type 1 Rubber Hose
Chains are not provided in kit.
Optional accessory. P/N: THCS
Reflector
Tension
Spring*
Tube Clamp
Igniter/Sensor Box
* Not all items illustrated may be provided with your heater.
Refer to kit contents on last page of the Series Manual.
1.0
Introduction
Tube Hanger
Reflector
3
•
•
Overview
Heater Components
10' (3 m) Primary/
Secondary
Combustion
Chamber(s)
Baffles
Radiant
Tube(s)
Advertisement
Table of Contents
