Introduction; Overview; Heater Components - Brant Radiant Heaters DX3L Series Manual

1.0

Introduction

•

Overview

Overview
The intent of this manual is to provide information regarding general safety, installation, operation and
maintenance of the tube heater. You must read, and understand, the instructions and safety warnings in
this manual before installing the tube heater. Additional literature on this and other products are available
at www.brantradiant.com.

Heater Components

Prior to installation, verify that the heater's gas type and voltage (as listed on the rating plate) match that
of your application. Also verify that you have received all heater contents included with your tube heater.
Reference last page for a list of the kit contents for your model heater. Materials not included in the heater
kit contents (e.g., screws, vent material, terminals, etc.) are the responsibility of the installer. Notify your
product representative or Brant Radiant Heaters Ltd. of any discrepancy or missing kit contents prior to
installing unit.
Figure 1.1 • Heater Components*
Reflector Center Support
Tube Hanger
Reflector End Cap with Clips
Burner Control Box
Igniter/
Sensor Box
Type 1 Rubber Flexible
Gas Connector
• Heater Components
Chains are not provided in kit.
Optional accessory. P/N: THCS
Tube Clamp
16 in. Burner Tube
* Not all items illustrated may be provided with your heater.
Tube Hanger
Reflector
Refer to kit contents of the last page of the Series Manual.
4
DX3L Series
10 ft. Primary/
Secondary
Combustion
Chamber(s)
Radiant
Tube(s)
Baffles