Instructions for Use
Working with the microscope
Recording image/video with Mode Control Mode
Adjusting light intensity
Rotate clockwise to increase light
intensity
On the front face of the OPMI, there are 5 white-colored LED indicators arranged in
an arc above the Mode Control knob. These LEDs are designed to roughly indicate
the set intensity level of the illumination under the corresponding mode. Note that
the illumination intensity of each mode can be set independently and will be
automatically memorized by the microscope even after power off.
000000-2466-133 -1.1-2022-06-22 for USA
Capturing image
Short click (t ≤ 0.8s) at the center of the Mode
Control knob to capture an image.
Recording video
Long click (t>0.8s) at the center of the Mode
Control knob to start video recording. To stop
the recoding, long click at the center again.
Rotate counter-clockwise to decrease light
intensity
Working with the microscope
40 / 65