Table of Contents
Advertisement
16
CM / C
M
OMMISSIONING
ANUAL
3.9
Configuration errors
If the following error message is displayed on the screen after you have booted the control system, this is
caused by the following:
The system file (system.dat) and system data selected in the project, which are stored residually in the flash
memory of the xPCI-800x controller control system, are different. This error can be cleared through a storage
procedure as described in the next section.
Advertisement
Table of Contents
Need help?
Do you have a question about the CPCI-8004 and is the answer not in the manual?