Table of Contents
Advertisement
General
Use the following information and procedures to operate an
Ovention
Conveyor Oven.
®
WARNING
Read all safety messages in the IMPORTANT SAFETY
INFORMATION section before operating this equipment.
In the event of emergency, turn OFF Main Disconnect
switch.
BURN HAZARD: Some exterior surfaces on unit will get
hot. Avoid unnecessary contact with unit.
Use caution and be aware of pinch points when slider
assembly is moving.
Conveyor Setting Information
Conveyor Ovens are designed to provide unequaled flexibility
and efficiency. Each oven has the capability of storing 36
different conveyor settings. All conveyor settings appear on the
Select Desired Item screen, which has eight additional sub-
screens.
At initial startup, the Select Desired Item screen will show
either sample conveyor settings or customer-specific,
preloaded conveyor settings. If the Select Desired Item screen
shows sample conveyor settings, these settings can be used
to help develop specific conveyor settings appropriate for the
installation. Refer to the "Programming Conveyor Settings"
procedure in this section for instructions on creating conveyor
settings.
Startup
1. Make sure the Main Disconnect switch is in the ON (I)
position (Models C2000 and C2600 only).
NOTE: The Conveyor Oven can be set up to cook from left-to-
right or right-to-left. This manual is written to reflect an
oven set to cook from left-to-right. The conveyor belts
on split belt models can travel in the same direction
only.
2. Push the Standby button to turn on the unit.
• The touchscreen will energize and show the name of the
oven and current software version for a few seconds.
Startup Screen
OVCM-1123
CAUTION
• After the Startup Screen, the Select Desired Item screen
appears. The first four pre-set conveyor settings are
available on this screen.
Touch to scroll to next screen and
view additional conveyor settings.
Select Desired Item Screen—Single Belt Model
3. Touch the desired conveyor setting.
• The oven heaters, air blowers, and cooling fans will start
up. Allow 10–15 minutes for the oven to reach setpoint
temperature.
• The touchscreen shows the selected setpoint
temperature and the current cavity temperature.
Touch to return to Select Desired Item
screen and select a different conveyor
setting.
When the oven reaches setpoint temperature, the oven begins
a temperature stabilizing period (a countdown screen appears).
OVEN TEMPERATURE STABILIZING
OVEN TEMPERATURE STABILIZING
TIME REMAINING
TIME REMAINING
Oven Stabilizing Screen
After the oven temperature stabilizes, the conveyor belt begins
moving and the Select Desired Item screen appears on the
touchscreen. The oven is now ready for cooking.
NOTE: The conveyor settings shown are for example only.
Depending on the configuration of the oven, the Select
Desired Item screen will show either sample settings or
customer-specific, preloaded settings.
9
OPERATION
Preheat Screen
5:00
5:00
Advertisement
Table of Contents
