Table of Contents
Advertisement
MAINTENANCE
Monthly Cleaning
1. Push the Standby button to turn off the unit, and allow it
to cool. Cooling fans will operate until the oven chamber
temperature drops below 140°F (60°C).
2. After the cooling fans shut off, disconnect the unit from the
power supply:
• For Model C1400, unplug the power cord.
• For Models C2000 and C2600, move the Main
Disconnect switch to the OFF (O) position, and unplug
the power cord.
3. Clean the Touchscreen.
NOTE: Do not spray cleaner directly onto the Touchscreen.
a. Spray a mild degreaser onto a soft, damp non-abrasive
cloth, and wipe the entire Touchscreen until clean.
Repeat, if necessary.
b. Allow the Touchscreen to dry completely.
c. Wipe away any hazy residue that remains on the
Touchscreen using a clean, dry non-abrasive cloth.
4. Remove and clean the two air filters on the back of the
oven. To clean each filter:
a. Slide the filter straight out the side of the filter bracket.
b. Spray the filter with water and/or soak in mild soap and
water.
c. Rinse clean and allow the filter to air dry.
d. When the filter is dry, reinstall the filter into the filter
bracket.
Filter Bracket
Air Filter
Cleaning the Air Filters
5. Using a soft bristle brush or compressed air, carefully
clean dust/debris buildup on each front door cooling fan
and fan guard.
IMPORTANT NOTE:
Use of cleaning chemicals not approved by Ovention when
cleaning the oven chamber will void the warranty.
6. Remove and clean the upper and lower jet plates inside the
a. Unlatch and open the oven door so that the inside of the
b. Remove each plate by gripping the two tabs on each
d. Using a non–abrasive nylon scouring pad, apply
e. Wipe the jet plates clean using a damp, non-abrasive
Door
Latch
7. Clean the visible areas of the oven chamber.
Air Filter
8. Reinstall the upper and lower jet plates into the oven
9. Close the oven door and secure both door latches.
10. Remove and clean each conveyor end stop and crumb tray
14
oven chamber. To clean the jet plates:
oven chamber is exposed.
plate and pulling straight out of the oven.
c. Spray Ovention Oven Cleaner onto both sides of each
jet plate. Allow the cleaner to sit for 3–5 minutes.
pressure to wipe away grease residue.
cloth and allow to air dry. Do not reinstall at this time.
Lower
Jet Plate
Cleaning the Jet Plates
a. Spray Ovention Oven Cleaner onto a non-abrasive
cloth, and wipe onto all the visible areas of the oven
chamber. DO NOT spray cleaner directly into chamber.
Allow the cleaner to sit for 3–5 minutes.
b. Using a non–abrasive nylon scouring pad, apply
pressure to wipe away grease residue.
c. Wipe the oven chamber clean using a damp, non-
abrasive cloth.
chamber.
as described in the "Daily Cleaning" procedure.
Oven
Door
Upper
Jet Plate
Tab
OVCM-1123
Advertisement
Table of Contents
