Hatco OVENTION C1400 Installation And Operating Manual page 15

11. Remove the belt guard(s) and disengage the drive belt(s).
Split belt models have a drive belt behind each side of the
conveyor frame.
a. Slide the belt guard off the drive belt located behind the
conveyor frame.
b. Remove the drive belt from the drive wheel by slightly
lifting the conveyor frame.
Front Door
Cooling Fan
Conveyor
Frame
(lift here)
Belt Guard
Drive Wheel
Removing the Belt Guard and Drive Belt
12. Clean the belt guard using mild soap and water. Rinse
clean and dry using a non-abrasive cloth.
13. For split belt models only, remove the oven door to allow
removal of the conveyor belt assembly.
a. Remove the two screws that secure the cover plate and
upper door hinge to the oven door.
b. Disconnect the wire harness connectors located behind
the cover plate, inside the door.
c. While supporting the oven door, unlatch and lift the door
off the lower oven hinge.
Wire
Harness
Connectors
Oven
Door
Lower Door
HInge
Removing the Oven Door—Split Belt Models Only
OVCM-1123
Drive Belt
Cover
Plate
Upper Door
Hinge
Lower Oven
Hinge
14. Remove the conveyor belt assembly. This step requires
two people.
For single belt models:
a. With one person on each side of the oven cavity, lift
up the conveyor belt assembly and slide the entire
assembly to the right.
b. When most of the conveyor belt assembly is through
the oven cavity, the person on the left should move to
the right side of the oven cavity and continue sliding the
assembly out of the cavity.
Lift up until recessed area
clears oven cavity, then
slide out to the right.
Removing the Conveyor Belt Assembly—Single Belt Model
For split belt models (oven door removed):
a. With one person on each side of the oven cavity, lift
up the conveyor belt assembly and slide the entire
assembly out the front of the oven cavity.
Removing the Conveyor Belt Assembly—Split Belt Model
15. Clean the conveyor belt assembly.
a. Spray Ovention Oven Cleaner onto both sides of the
conveyor belt assembly. Allow the cleaner to sit for 3–5
minutes.
b. Using a non–abrasive nylon scouring pad, apply
pressure to wipe away grease residue on the conveyor
belt and frame.
c. Spray clean with water and dry using a non-abrasive
cloth. Additional air dry time may be necessary before
re-installation.
16. Reinstall the conveyor belt assembly, oven door, belt
guard, crumb trays, and conveyor end stops by reversing
the above procedure.
15
MAINTENANCE
Conveyor Belt
Assembly
Conveyor Belt
Assembly