Table of Contents
Advertisement
4.2.3
Setting the Program
The Electronic Load is able to select customized basic tests, and link them into a program test
for automatic execution.
The
key is used to select or recall program for local control. There are ten programs
PROG
(1-10), and each of them has ten sequences to map files from 1 to 100. The program 1 maps
files from 1 to 10. Table 4-1 shows the relationship between the program sequence and the
corresponding files.
Program 1 Sequence No.
Corresponding File No.
Program 2 Sequence No.
Corresponding File No.
:
Program 10 Sequence No.
Corresponding File No.
Table 4-1 Relationship of the Program Sequence and the Corresponding File
In running a program you must set its corresponding file parameters first. If one program
sequence is not enough for you to test the UUT, you can use program chain function to get
more sequences.
Press
key, and the LCD will display as follows. Press number 1 -10 followed by
PROG
to recall the program from EEPROM, or use ▲, ▼ keys to edit the program.
ENTER
Setting the Active Channels
The LCD displays the active channels for the program to control. The LED channel
indicators will be active if the channel is active. The channel can be active only when it
exists and SYNC RUN mode is ON. When the channel is not selected or does not exist,
the channel number will not appear. Press number 1 to 8 to enable or disable the active
channel.
1.
Setting the Program Chain
The chain function of program enables you to chain program so as to get more sequences
for testing. Set program chain number to 0 means no program chain. Program chain
function can chain itself for loop test, or chain other programs. Press
chain itself for loop test. The default setting is 0.
1
2
3
4
1
2
3
4
1
2
3
4
11
12
13
14
1
2
3
4
91
92
93
94
PROGRAM SELECT
No:
1
ACTIVE CHANNEL
1
3
5 6 7 8
PROGRAM CHAIN
No:
1
5
6
7
8
5
6
7
8
5
6
7
8
15
16
17
18
5
6
7
8
95
96
97
98
1
Local Operation
9
10
9
10
9
10
19
20
9
10
99
100
,
to set
ENTER
4-7
Advertisement
Table of Contents
