Table of Contents
Advertisement
2.
Installation
2.1
Introduction
This chapter explains how to install the Load to Mainframe and its connections. In addition,
it also covers the power-on check procedure and application considerations.
2.2
Inspection
As soon as the instrument is unpacked, inspect any damage that might have occurred in
shipping. Keep all packing materials in case that the instrument has to be returned. If any
damage is found, please file a claim to the carrier immediately. Do not return the instrument
to Chroma without prior approval.
In addition to this manual, be sure that the following items are also received along with the
Mainframe and Load.
Mainframe: Power Cord, Manual
Load Module: Measurement and Load Cables
2.3
Installing the Modules
CAUTION
Load module can be damaged by electronic discharge (static electricity). Use standard
anti-static work practices when you handle and install modules. Avoid touching the
connector and the circuit board.
Chroma 6334 Mainframe has room for four single-width Loads (63302, 63303), or two
double-width Loads (63306). Loads can be combined in the Mainframe in any order.
Chroma 6332 mainframe has room only for two single-width Loads or one double-width
Load. The module installation procedures for both Mainframes are the same. Only
screwdriver is required when installing Load to Mainframe.
Procedures
1.
Power off the Mainframe and disconnect the power cord.
2.
Remove any packing materials on the Mainframe.
3.
Start to install the modules in the slot (see Figure 2-1).
4.
Slide the load module into the Mainframe slot along the rail.
5.
Secure the module in place with screwdriver (see Figure 2-1).
6.
Install each additional module in the next slot likewise.
Installation
2-1
Advertisement
Table of Contents
