Electrolux SAHARA Service Manual page 41

Remove the worktop.
Remove the right side panel.
Disconnect the connector.
Pull the probe up to remove it from its seat.
9.17 NTC PROBE, KICK PLATE PANEL – OPTIFLOW
NTC
40/56
Remove the plinth.
Losen the screw.
Remove the worktop.
Remove the right side panel.
We recommend you remove the drum rotation motor to make this
operation easier
Disconnect the probe.
Remove the probe holding metallic clip (2).
Pull the probe (1) upwards in order to remove it from its slot.
Pull the NTC probe up. You can
help yourself by pushing it from the
left side after opening the heat
exchanger compartment door.
Technical Support MP
DISASSEMBLY
599 796-724 Rev.0.2