Table of Contents
Advertisement
5-4. Setting the Power Saving Mode when a Person
Leaves the Monitor
The sensor on the front of the monitor detects the movement of the operator when Presence Sensor is set to "On".
When a person moves away from the monitor, it shifts to the power saving mode automatically and does not display
the images on the screen to reduce the power consumption. When a person comes near the monitor again, it
recovers from the power saving mode and displays the images. The sensitivity and time until the power saving
mode is activated can be set according to the monitor usage environment and movement of the user.
Note
• At the time of shifting to power saving mode, the message that indicates shifting is displayed.
Attention
• This setting cannot be used during "RadiCS SelfQC" execution.
Procedure
1. Select "PowerManager" from the Adjustment menu, and press
2. Select "Presence Sensor" from "PowerManager", and press
3. Select "On" or "Off" with
4. Press
to exit.
5. After selecting "On", set the details.
Item
Time
Sensitivity
Reset
Note
• To use the monitor comfortably, increase the sensitivity for high temperatures, which reduces the detection sensitivity,
and reduce the sensitivity for low temperatures, which increases the detection sensitivity.
or .
Setting Range
5, 30 sec
1, 3, 5, 10, 15, 30, 45, 60 min
Level 5
Level 4
Level 3
Level 2
Level 1
-
.
.
Description
Specifies the time from when a person leaves the monitor until
the "No Presence detected" message appears. The monitor
shifts to the power saving mode about 20 seconds after the
message is displayed.
When the setting level is high ("Level 5" at maximum), even
minor movements of a person are detected, causing the
monitor to shift to the power saving mode only infrequently.
On the other hand, when the setting level is low ("Level 1" at
minimum), only major movements of a person are detected,
allowing the monitor to shift to the power saving mode
frequently. The Presence Sensor function is activated when
the sensor on the front of the monitor detects the movement of
heat. Therefore, the sensitivity should be changed depending
on the typical user's clothes or the typical room temperature. If
the monitor shifts to or recovers from the power saving mode
contrary to your expectations, try changing the setting level.
This function resets all adjustments to the default settings.
Chapter 5 Power Saving Functions
29
Advertisement
Table of Contents
