Peak Load Prevention; Com Module Selection; Availability Of Miele Digital Products; Wifi / Lan - Miele PDR 910 EL SOM Operating And Installation Instructions

Supervisor level

Peak load prevention

With this function, the application of a hygiene programme is not amended when a peak
load signal is in place. The heater stays switched on.
Off
- Factory default:
On
-

COM module selection

This tumble dryer is equipped with an integrated WiFi module. However, the dryer can
also be equipped with an external module.
- Factory default:
Off
Internal mod. Domestic
-
The internal WiFi module is used.
External mod. Professional
-
An XKM module is inserted into the module slot.

Availability of Miele digital products

The ability of Miele digital products depends on the availability of the services in your
country.
The different services are not available in all countries.
For information about availability, please visit www.miele.com.

WiFi / LAN

Control the networking of your tumble dryer.
Networking of the tumble dryer for use with the digital Professional tools is only possible
with the external module. The internal module can only be used by the Miele Customer
Service Department.
- Deactivate (visible when the network is activated)
The network remains set up; the WiFi function is switched off.
Activate
- (visible when the network is deactivated)
The WiFi function is reactivated.
Connection status
-
The following values are displayed:
– the quality of WiFi reception
– the network name
– the IP address
Set up again
- (visible when set up)
Resets the WiFi login (network) to immediately re-establish a new connection.
- Reset (visible when set up)
The network is no longer set up. A new connection has to be established in order to use
the network again.
– The WiFi is switched off.
54
(visible when the network is activated)