External Applications; Peak Load Signal; Peak Load Prevention; Select Kom Module - Miele PDR 908 HP Operating And Installation Instructions

External applications

Peak load signal

External hardware is connected via the
Miele XCI Box.
The peak-load negotiation function
enables the tumble dryer to be
connected to an energy-management
system. When a signal is registered,
the tumble dryer's heater is switched
off for a short period or the appliance
is prevented from being switched on.
The tumble dryer may only be
operated with a peak-load system if
this system is connected to the tumble
dryer via the Miele XCI Box.
– Factory default: No function
– Peak load with 230 V
– Peak load with 0 V

Peak load prevention

With this function, the application of a
hygiene program is not amended
when a peak-load signal is in place.
The heater stays switched on.
– Factory default: Off
– On

Select KOM module

This tumble dryer is equipped with an
integrated WiFi module. However, the
tumble dryer can also be equipped
with an external module.
– Off
– Internal module (factory default)
The internal WiFi module is used.
Supervisor level
– External module
An XKM module or RS232 module is
inserted into the module slot.

WiFi

Control the networking of your tumble
dryer.
– Setup
This message only appears if the
tumble dryer has not yet been
connected to a WiFi network.
– Deactivate (visible when the network
is activated)
The network remains set up; the WiFi
function is switched off.
– Activate (visible when the network is
deactivated)
The WiFi function is reactivated.
– Connection status (visible when the
network is activated)
The following values are displayed:
– The quality of WiFi reception
– The network name
– The IP address
– Reset (visible when set up)
Resets the WiFi login (network) to
immediately re-establish a new
connection.
– Reset (visible if already set up)
The network is no longer set up. A
new connection has to be
established in order to use the
network again.
– The WiFi is switched off
– The WiFi connection will be reset
to the factory default setting
99