Important Safety Instructions - Snom HD101W User Manual

The applied nameplate is located at the bottom or rear of the product.
When using your telephone equipment, basic safety precautions should always be followed to reduce
the risk of fire, electric shock and injury, including the following:
1. This product should be installed by a
qualified technician.
2. This product should only be connected
to the host equipment and never directly
to the network such as Public Switch
Telephone Network (PSTN) or Plain Old
Telephone Services (POTS).
3. Read and understand all instructions.
4. Follow all warnings and instructions
marked on the product.
5. Unplug this product from the wall outlet
before cleaning. Do not use liquid or
aerosol cleaners. Use a damp cloth for
cleaning.
6. Do not use this product near water such
as near a bath tub, wash bowl, kitchen
sink, laundry tub or swimming pool, or
in a wet basement or shower.
7. Do not place this product on an unstable
table, shelf, stand or other unstable
surfaces.
8. Slots and openings in the back or bottom
of the telephone base and handset are
provided for ventilation. To protect them
from overheating, these openings must
not be blocked by placing the product
on a soft surface such as a bed, sofa or
rug. This product should never be placed
near or over a radiator or heat register.
This product should not be placed in
any area where proper ventilation is not
provided.
9. This product should be operated only
from the type of power source indicated
on the marking label. If you are not
sure of the type of power supply on the
premises, consult your dealer or local

Important safety instructions

power company.
10. Do not allow anything to rest on the
power cord. Do not install this product
where the cord may be walked on.
11. Never push objects of any kind into
this product through the slots in the
telephone base or handset because they
may touch dangerous voltage points or
create a short circuit. Never spill liquid
of any kind on the product.
12. To reduce the risk of electric shock, do
not disassemble this product, but take it
to an authorized service facility. Opening
or removing parts of the telephone base
or handset other than specified access
doors may expose you to dangerous
voltages
reassembling can cause electric shock
when the product is subsequently used.
13. Do not overload wall outlets and
extension cords.
14. Unplug this product from the wall outlet
and refer servicing to an authorized
service facility under the following
conditions:
• When the power supply cord or plug
is damaged or frayed.
• If liquid has been spilled onto the
product.
• If the product has been exposed to
rain or water.
• If the product does not operate
normally by following the operating
instructions.
controls that are covered by the
operation
adjustment of other controls may
EN - 2
or other risks.
Adjust only
instructions.
Incorrect
those
Improper